Endress+Hauser RID 261 Bedienungsanleitung Seite 31

Downloaded from www.Manualslib.com
Value tabel:
S 1 2
1
Value 2
Example:
Address 6 is in accordance with the value 2+4, so:
S2/2 ⇒ ON
S2/3 ⇒ ON (see figure below)
Hint: Changes to the DIP switch settings are immediately
active (no reset required). The settings for the DIP switches for
displaying volumetric flow from a flow measuring device in
address 68 can be found in chapter 11.1.
Display elements LC display
Display
In addition to the process value the PROFIBUS-PA display also
delivers the following information:
Display
[1] Alarm set point infringement from PROFIBUS-PA Profile V3.0 (also see chap. 11.2)
manuals search engine
6. Setting up and operation
3 4 5 6 7 8
4 8 16 32 64 128
7 digit LC display
7.5 mm character height
Description
Start:
Display after reset
Process value: Number (poss. with
negative prefix) with maximum 3
decimal points and OK marks
indicating process value status is OK
Process value with alarm
markings:
Process value status OK or
[1]
UNCERTAIN alarm condition
29