Reely EP Buggy Ranger Brushless 4WD RtR Handbuch Seite 44

• Briefly press the set-up button, to select the next value. Check the flash signal.
Once the desired value is reached (for 40% the red LED will flash 1 x long and 2 x short), switch off the drive control
unit. This concludes the programming, the value is saved.
If you wish to adjust other settings (e.g. low-voltage protection), then proceed as described above.
Release the set-up button exactly when the green LED flashes for the corresponding function to be
adjusted (or the corresponding beep tone is heard); an exact description of the individual functions is
given further below.
Then press the set-up button shortly as often as required until the red LED flashes correspondingly for
the desired setting value.
If the drive control unit is switched off, the current setting and/or value will be saved.
The settings/values with the grey background are the factory settings made by the manufacturer.
# Green LED blinks... Function
(+ beep)
1 1x short Drive function
2 2x short Handbrake
3 3x short Undervoltage protection off
4 4x short Start mode
5 1x long Maximum brake power
6 1x long, 1x short Max. speed for driving
backwards
7 1x long, 2x short Minimum brake power
8 1x long, 3x short Neutral range
9 1x long, 4x short Timing
10 2x long Motor type
11 2x long, 1x short Excess temp. protection +95°C
• Function #1, green LED flashes 1x short: Drive function
In this settings menu the drive control unit can be switched between "forwards/brake" and "forwards/brake/reverse"
(factory setting).
• Function #2, green LED flashes 2x short: Handbrake
The handbrake function stops the vehicle from rolling when it is on an uneven surface or slope. The higher the set
value of the handbrake function, the less the vehicle rolls when it is resting on a slope. A standard electric motor - at
rest - has a certain amount of braking strength due to the magnets it contains - a brushless electric motor, however,
does not.
Settable values are 0%, 5%, 10% (factory setting) 15%, 20%, 25%, 30%, 40%.
1x short 2x short
Forward/brake Forward/brake/
backward
0 5%
2.6V/cell
Soft Normal
25% 50%
25% 50%
= handbrake 0%
6% 9%
0.00 3.75
Brushless
Off
Red LED blinks...
3x short 4x short 1x long
10% 15% 20%
2.8V/cell 3.0V/cell 3.2V/cell 3.4V/cell
Fast Very fast
75% 100%
75% 100%
20% 40%
12%
7.50 11.25 15.00
1x long, 1x long, 1x long,
1x short 2x short 3x short
25% 30% 40%
18.75 22.50 26.25
41