Hitachi RAS-18GH5 Bedienungsanleitung Seite 7

AUTOMATIC OPERATION
The device will automatically determine the mode of operation, HEAT, COOL or DEHUMIDIFY depending on the
initial room temperature. The selected mode of operation will not change when the room temperature varies.
RESET
Condition of Automatic Operation
Initial room temperature
(approx.)
Over 27°C
Under 23°C
Downloaded from www.Manualslib.com
1
START
STOP
Function
DEHUMIDIFY
23~27°C
manuals search engine
Press the FUNCTION selector so that the display indicates the
mode of operation.
When AUTO has been selected, the device will automatically determine
the mode of operation, HEAT, COOL or DEHUMIDIFY depending on
the initial room temperature.
Press the (START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
As the settings are stored in memory in the remote controller, you only have to
press the (START/STOP) button next time.
You can raise or lower the temperature setting as necessary by maximum of 3°C.
Press the temperature button and the temperature setting
will change by 1°C each time.
The preset temperature and the actual room temperature may vary
somewhat depending on conditions.
The display does not indicate the preset temperature in the AUTO mode.
If you change the setting, the indoor unit will produce a beep.
Temperature setting
COOL 27°C
Slightly lower than the
room temperature
HEAT 23°C
– 7 –
(AUTO)
FAN SPEED
HI at start, MED or LOW
after the preset temperature
is reached
LOW
HI at start, MED or LOW
after the preset temperature
is reached