Marking Of The Fitting - Mankenberg Rp 824 Originalbetriebsanleitung

Original operating manual
pilot-operated pressure regulators RP 824

5 Marking of the fitting

Each fitting bears the following markings as a minimum:
For Marking
Manufacturer MANKENBERG
Fitting design Pressure-reducing + type or
Back pressure regulator + type
Nominal diameter e.g. DN or G and numerical
value
Nominal pressure PN or Class and numerical
value
Pressure range Pressure range and numerical
values
Max. permitted Temperature and numerical
temp. value
Body material e.g. CrNiMo steel
Flow direction Indicated by an arrow
The markings (in the case of fittings made of deep-drawn stainless steel, they are etched into the body) should
neither be covered nor painted over, so that the fitting remains identifiable.
operating_manual_RP824_en_de.25.1 Issue 22.12.2025
Remark
See section Further information [Page 19]
address
Design name as per accompanying
MANKENBERG data sheet
Numerical value for DN in [mm], for G in [inches]
Zahlenwert für PN in [bar], für Class in [lbs/square
inch]
Numerical value for PN in [bar], for Class in [lbs/
square inch]. Unless otherwise indicated, all data
give the overpressure above atmospheric.
If 2 numerical values are given, these apply to the
inlet and outlet pressure.
Temperatures above 50 °C entail a reduced
pressure resistance. This must be considered for
the corresponding material in accordance with the
DIN EN 1092 standard
CrNiMo steel = high-alloy austenitic steel
8
for the
Made in Germany