Before Initial Operation; Display; Fast Cool Mode - Pkm KG 300.4A++NF IX Bedienungsanleitung

4.1 Before initial operation

1. Clean the appliance thoroughly. Be very careful especially inside the appliance
(look at chapter
2. If the accessories inside the appliance are not fitted in their correct position,
replace them according to the image in chapter 4.
3. Switch on the appliance. Use the appliance 24 hours after initial operation for
the first time to ensure proper operation.
4. The appliance must be connected to the mains properly.
5. If the appliance was disconnected from the energy supply, wait 5 minutes
before you restart it.
6. Do not overfill the appliance

4.2 Display

A
Temperature setting
1. Initial use: The complete display is switched on for 3 seconds. The appliance is
operating now.
2. Temperature setting: Press button A repeatedly until you have set the desired
temperature. The recommended temperature during operation at room
temperature is 4
3. Interruption of the energy supply: When you switch on the appliance again, the
complete display is switched on for 3 seconds. The appliance will operate in
previous setting.
4. When an error occurs, the relevant LED indicates a combined error code.
5. When the system operates properly, the set temperature is indicated only.

4.3 Fast cool mode

The mode is activated by pressing button B. The LED for
temperature setting is 2
any point of time by pressing button A.
FAST COOL
CLEANING AND MAINTENANCE
0 C.
C. The mode is active for 150 minutes. You can cancel
0
).
B
Fast Cool
36
1-5
Cooling levels in
goes on. The
FAST COOL
C
0