Ransomes LBMA171 Montage-, Sicherheits- Und Bedienungshandbuch Seite 13

6 ASSEMBLY
6.2 ASSEMBLY—3-UNIT GANG MOWER
Assemble each cutting unit as single unit mower
instruction. Refer to page 10.
1. (Fig. 3). To one of the cutting units bolt
on the extension wings (A) one each side
of the unit frame. Two long bolts (B) are
used at the rear which go through the
lugs of the extension wings and the unit
frame. Two short bolts (C) are used to
secure the front of the extension wings.
All must be tightened securely.
2. (Fig. 4). From two of the short drawbars
take the universal couplings (A) and bolt
these into the towing points (B) on the
extension wings, ensuring that the bolts
are not overtightened as this will cause
distortion. The universal coupling must
be free to swivel. The lubricating nipples
must point upwards.
3. (Fig. 3). Couple the two rear units to
the towing point on the extension wings
ensuring that the chains (D) hang below
the drawbars.
RANSOMES GANG MOWERS
SPORTCUTTER Mk11, MAGNA Mk13
SAFETY AND OPERATORS MANUAL
Fig 3
Fig 4
en-13