Kenwood kdc-x7100dab Bedienungsanleitung Seite 19

BLUETOOTH®
MIC GAIN LEVEL –10 to LEVEL +10 (LEVEL –4):
The sensitivity of the microphone increases as the
number increased.
NR LEVEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the noise
reduction level until the least noise is being heard
during a phone conversation.
ECHO CANCEL LEVEL –5 to LEVEL +5 (LEVEL 0): Adjust the echo
cancellation delay time until the least echo is being
heard during a phone conversation.
Make the settings for receiving a call
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select an item (see the
following table), then press the knob.
3
Repeat step 2 until the desired item is selected or
activated.
4
Press and hold to exit.
To return to the previous setting item, press
SETTINGS
AUTO ANSWER 1 to 30: The unit answers incoming call automatically
in the selected time (in seconds). ; OFF: Cancels.
BATTERY/ AUTO: Shows the strength of the battery and signal
SIGNAL* when the unit detects a Bluetooth device and the
Bluetooth device is connected. ;
OFF: Cancels. Date is shown.
* Functionality depends on the type of the phone used.
Default: XX
Make a call
You can make a call from the call history, phonebook, or dialing the number. Call by
voice is also possible if your mobile phone has the feature.
1
Press to enter Bluetooth mode.
"(First device name)" appears.
• If two Bluetooth phones are connected, press
"(Second device name)" appears.
2
Turn the volume knob to select an item (see the following table), then press the knob.
3 2
Repeat step
stated on the selected item.
4
Press and hold
To return to the previous setting item, press
CALL HISTORY (Applicable only if the phone supports PBAP.)
1 Press the volume knob to select a name or a phone number.
2 Press the volume knob to call.
.
PHONE BOOK (Applicable only if the phone supports PBAP.)
1 Turn the volume knob quickly to enter alphabet search mode (if the phonebook contains
Default: XX
2 Turn the volume knob to select a name, then press the knob.
3 Turn the volume knob to select a phone number, then press the knob to call.
• The phonebook of the connected phone is automatically transferred to the unit when
• Contacts are categorized as: HOME, OFFICE, MOBILE, OTHER, GENERAL.
• This unit can display only non-accent letters. (Accent letters such as "Ú" is shown as "U".)
until the desired item is selected/activated or follow the instructions
to exit.
• "INCOMING", "OUTGOING", or "MISSED" is shown on the lower part of the display to
indicate the previous call status.
• Press DISP to change the display category (NUMBER or NAME).
• "NO DATA" appears if there is no recorded call history.
many contacts).
The first menu (ABCDEFGHIJKLMN) appears.
• To go to the other menu (OPQRSTUVWXYZ1*), press J / K.
• To select the desired first letter, turn the volume knob or press S / T, then press
the knob.
Select "1" to search with numbers and select "*" to search with symbols.
pairing.
again to switch to another phone.
.
ENGLISH
15