Inserting Battery - Laserliner Climadata Stick Handbuch

2
3
1 Sensor
2 Measurement active
1

Inserting battery

Open the battery compartment and insert battery according to the symbols.
Be sure to pay attention to polarity. With measurement recording activated,
no LED flashing or LED (2) flashing red every 60 seconds indicates the battery
charge is low.
2.
2 Software installation / Commissioning
1.
12
EN
1
4
5
6
1.
Load the CD in the drive and follow
the installation routine. Close the
installation program once installation
has been successfully completed.
8
7
3
Alarm function
4 Battery compartment
5 Start measurement recording
6 USB interface
7 Protective cap
8 Wall bracket