Technical Data - Hilti SF 10W-A22 Bedienungsanleitung

2.5 Power tool overloading and overheating indicator
The power tool is equipped with an electronic protection system to prevent overloading and overheating. The power
tool switches itself off automatically in the event of overloading and overheating. After releasing the control switch, the
power tool may not restart immediately when the switch is pressed again (while the power tool is cooling down).
LEDs light constantly
-

3 Technical data

Right of technical changes reserved.
Power tool
Rated voltage (DC voltage)
Weight in accordance with EPTA procedure 01/2003
Speed in 1st gear
Speed in 2nd gear
Speed in 3rd gear
Speed in 4th gear
Torque with tool set to drilling symbol (soft/flexible joint)
Torque range (15 settings)
Drilling diameter range in wood (hard)
Drilling diameter range in wood (soft)
Drilling diameter range in metal
NOTE
The sound pressure and vibration values given in these instructions have been measured in accordance with a
standardized test and may be used to compare one electric tool with another. They may be used for a preliminary
assessment of exposure. The data given represents the main applications of the electric tool. However, if the electric
tool is used for different applications, with different accessories or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period. An accurate estimation of exposure should also take into
account the times when the tool is switched off, or when it is running but not actually being used for a job. This may
significantly reduce exposure over the total working period. Identify additional safety measures to protect the operator
from the effects of noise and/or vibration, for example: maintain the electric tool and accessories, keep the hands
warm, organisation of work patterns.
Power tool
Typical A-weighted sound power level, L
Typical A-weighted emission sound pressure level, L
Uncertainty for the given sound level, K
Screwdriving without impact action, a
Drilling in metal, a
h,D
Uncertainty for triaxial vibration values (drilling), K
Battery
Rated voltage
Capacity
Weight
LEDs blink
LED 1, 2, 3, 4
WA
pA
h
B 22/1.6 Li‑Ion
21.6 V
1.6 Ah
0.48 kg
Power tool status
Power tool overloaded or
overheated
SF 10W-A22 SF 8M-A22
21.6 V 21.6 V
2.7 kg 2.7 kg
0...310/min 0...320/min
0...530/min 0...550/min
0...1,210/min 0...1,250/min
0...2,100/min 0...2,150/min
Max. 72 Nm Max. 50 Nm
2...12 Nm 2...12 Nm
1.5...20 mm 1.5...20 mm
1.5...50 mm 1.5...32 mm
1.5...13 mm 1.5...20 mm
SF 10W-A22 SF 8M-A22
86 dB (A) 88 dB (A)
75 dB (A) 77 dB (A)
3 dB (A) 3 dB (A)
< 2.5 m/s² < 2.5 m/s²
< 2.5 m/s² < 2.5 m/s²
1.5 m/s² 1.5 m/s²
B 22/3.3 Li‑Ion
21.6 V
3.3 Ah
0.78 kg
en
13