General Characteristics; Intended Use - Airpress Combi Dry Basic 3 Bedienungsanleitung

ADDRESSES OF ASSISTANCE CENTRES
In the event of breakdown or malfunction of the machine, switch it off and do not tamper with it.
If repairs are needed, apply only to a technical assistance centre approved by the manufacturer and insist on the use of
original spare parts.
Failure to comply with the above may endanger the safety of the machine.
INTRODUCTION
Keep this manual with care for future consultation; the use and maintenance manual is an integral part of the
machine. Read this manual carefully before carrying out any operations on the compressor unit.
The installation of the compressor unit and all operations involving it must be performed in conformity with the
regulations in force concerning electric plants and personal safety.
CHARACTERISTICS AND SAFETY PRECAUTIONS
MACHINE WITH AUTOMATIC START
BEFORE REMOVING THE PROTECTIVE GUARDS TO CARRY OUT ANY MAINTENANCE ON THE MACHINE,
SWITCH OFF THE ELECTRIC POWER SUPPLY AND DISCHARGE THE RESIDUAL PRESSURE INSIDE THE UNIT.
ALL WORK ON THE ELECTRIC PLANT, HOWEVER SLIGHT, MUST BE CARRIED OUT BY PROFESSIONALLY
SKILLED PERSONNEL.
- To prevent internal corrosion, which could compromise the safety of the compressed air tank, the
condensation that is produced must be discharged at least once a week.
- The thickness of the tank should be controlled against legislation currently in force in the country where the
tank is installed.
- The tank cannot be used and must be replaced if the thickness falls below the level given in the instruction
documents for the tank.
- The tank can be used within the temperature limits given in the conformity declaration.
The manufacturer does not accept responsibility for damage caused as a result of negligence of failure to abide by the
instructions given above.
THIS MACHINE IS NOT SUITABLE FOR EXTERNAL INSTALLATION
THIS MACHINE CORRESPOND TO THE ESSENTIAL SAFETY REQUIREMENTS FORESEEN FROM THE
EUROPEAN STANDARD (98/37 CE), AND THE RULE EN 292

1.0 GENERAL CHARACTERISTICS

The AIRPRESS compressor units type Combi Basic and Combi Dry Basic use single-stage screw rotary air compressors
with oil injection.
The system is self-bearing and does not require bolts or other devices to anchor it to the floor.
The unit is completely assembled in the factory; the necessary connections for setting it up are:
• connection to the power mains (see installation chapter)
• connection to the compressed air network (see installation chapter)

2.0 INTENDED USE

The Combi Basic and the Combi Dry Basic compressor has been built to supply compressed air for industrial use.
The machine cannot be used in premises where there is a risk of fire or explosion or where work is carried out which
releases substances into the environment which are dangerous with regard to safety (for example: solvents, inflammable
vapours, alcohol, etc.).
In particular the appliance cannot be used to produce air to be breathed by humans or used on direct contact with
foodstuffs. These uses are allowed if the compressed air produced is filtered by means of a suitable filtering system
(Consult the manufacturer for these special uses.)
This appliance must be used only for the purpose for which it was specifically designed.
All other uses are to be considered incorrect and therefore unreasonable.
The Manufacturer cannot be held responsible for any damage resulting from improper, incorrect or unreasonable use.
Cod. 2200772300 00 - Edition 04/2003 - 41
ENGLISH