Berbel KNX-RF Montageinformationen Seite 19

Installation
2.1.2 Prepare the ceiling lift hood
Skyline/Skyline Edge
☞ Use an SW 2.5 (Inbus) Allen key to unscrew the screws on
the cover.
☞ Remove the cover upwards. Pay attention to the support
cable and the mains cable.
☞ Make sure that the correct side of the ceiling lift hood is
selected. Access takes place from above the device.
6003620_0 – 02.05.2017
Skyline Round
☞ Use an SW 2.5 (Inbus) Allen key to unscrew the screws in
the cover.
☞ Remove the cover upwards. Pay attention to the support
cable and the mains cable.
19