Siemens PS791-2DC Betriebsanleitung Seite 44

English
How to remove the power supply adapter
WARNING
Danger from line voltage
Opening the device and removing the power supply adapter
must only be performed by electrical specialists!
Connect power supply cables only when the power is turned
off!
Start the SCALANCE W786 or HiPath Wireless Outdoor
Access Point only when you have screwed down the housing
cover again so that there is once again protection against
touching live parts!
Follow the steps below to remove a power supply adapter from
a SCALANCE W786 or HiPath Wireless Outdoor Access Point:
1. Disconnect the power supply cable from the power supply
adapter.
2. Loosen the securing screw of the power supply adapter
(position A in the figure above).
3. Pull the loop (position B in the figure above) to remove the
connector on the rear of the power supply adapter from
the socket in the housing and remove the power supply
adapter.
44
Operating Instructions (compact) PS791-2AC / PS791-2DC
A5E01160517-06