Siemens PS791-2DC Betriebsanleitung Seite 42

English
Follow the steps below to fit and connect a power supply
adapter:
1. Fit the power supply adapter in the SCALANCE W786 or
HiPath Wireless Outdoor Access Point as shown in the
figure above. The connector on the rear of the power
supply adapter must engage fully in the socket of the
housing. The entire rear surface of the power supply
adapter must make contact with the inner surface of the
SCALANCE W786 or HiPath Wireless Outdoor Access
Point.
CAUTION
Damage to the device
Only use the loop (position B in the figure above) to remove
the power supply adapter from the SCALANCE W786 or
HiPath Wireless Outdoor Access Point! This prevents the
connector skewing on the back of the power supply adapter
and breaking off.
2. Connect the power supply adapter and the SCALANCE
W786 or HiPath Wireless Outdoor Access Point with the
screw supplied with the power supply adapter (position A
in the figure above).
42
Operating Instructions (compact) PS791-2AC / PS791-2DC
A5E01160517-06