Safety Instructions For Maintenance - Husqvarna Rigg 900 C Betriebsanleitung

• In order to avoid a hazard due to inadvertent
resetting of the thermal cut-out, this appliance
must not be supplied through an external switching
device, such as a timer, or connected to a circuit that
is regularly switched on and off by the utility.
• Make sure that the power supply for the product is
supplied by separate transformers that are used for
industrial purpose only.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
Use only grounded outdoor extension cables with
grounding plugs and grounding outlet that accepts the
product power plug.
The product has a grounded power cord and power
plug. Always connect the product to a grounded mains
outlet. This decreases the risk of electrical shock.
Do not use electrical adapters with the product.
Extension cables
• Use only approved extension cables with applicable
properties.
• The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
• Use grounded extension cables.
• When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
• Make sure that the extension cable is out of the
way and the product during operation. This prevents
damage to the extension cable.
2157 - 001 - 07.03.2024
Incorrect connection can
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
• Do not make modifications to safety devices.
ON/OFF switch
The ON/OFF switch is used to start and stop the power
supply to the product.
To do a check of the ON/OFF switch
Product overview on page 3 for information
Refer to
about where the ON/OFF switch is on your product.
1. Turn the ON/OFF switch to the ON (I) postion.
2. Make sure that the indicator for control voltage
comes on.
3. Turn the ON/OFF switch to the OFF (0) position.
4. Make sure that the indicator for control voltage goes
off.
Safety rope
The safety rope is used to attach the product to the top
of the roof on a storage tank.
WARNING:
without a correctly installed safety rope.
To install the product on a storage
Refer to
tank on page 9 .
To do a check of the safety rope
• Examine all parts for wear and damage. Replace
worn or damaged parts.
• Make sure that there is no corrosion.
• Make sure that the safety rope is installed correctly.
• Let an approved person do an inspection if you are
not sure.

Safety instructions for maintenance

WARNING:
instructions that follow before you use the
product.
• Only do the maintenance as given in this operator's
manual. Let an approved service agent do all other
servicing.
Read the warning
Do not use the product
Read the warning
7