Fujitsu FP-410 Handbuch Seite 58

C-4 Setup Items
(1) MEMORY SWITCH setup items
No. Item
1 POWER ON
STATUS
2 RECEIVE
BUFFER
3 BUSY
CONDITION
4 RECEIVE
ERROR
5 AUTO LF
6 DSR(#6)RESET
7 INIT(#25)
RESET
8 INIT(#31)
RESET
9 BM CHECK AT
POW-ON
10 COVER OPEN
ERROR
11 RETURN TO
UP
12 RETURN TO
SETUP MENU
Explanation
-Specifies reporting the power-on
state.
-Specifies the capacity of the receive
buffer.
-Specifies conditions that determine
the printer busy status.
-Specifies how to handle receive
errors
-This item is valid only for the serial
interface.
-Specifies automatic line feed using
the CR code.
-This item is valid only for the Parallel
interface.
-Specifies the reset operation using
the DSR(#6) signal.
-This item is valid only for the serial
interface.
-Specifies the reset operation using
the INIT(#25) signal.
-This item is valid only for the serial
interface.
-Specifies reset using the INIT(#31)
signal.
-This item is valid only for the Parallel
interface.
-Specifies the adjustment of the
leading edge of the paper at
power-on.
-This item is valid only when the black
mark detection unit is installed and
"BM sensor installed" is set.
-Specifies how to handle a cover open
error during printing.
-Returns the menu to the selection
mode for setup group items.
-Returns the menu to the setup mode
menu.
57
Detail Setup Item
ENABLE
DISABLE
45BYTE
4KBYTE
BUFFERFULL
OFFLINE/BUF-FER
FULL
IGNORE
?PRINT
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
ENABLE
DISABLE
AUTO RECOVERY
RECOVERY BY
CMND