Fujitsu FP-410 Handbuch Seite 50

B-3. USB Interface
(1) Type-B Connector: 4Pin
Item Signal Name
1 BUS5V
2 D-inB
3 D+inB
4 SG1
(2) Type-A Connector: 8Pin
Item Signal Name
1 USB5V2
2 D-OUTA2
3 D+OUTA2
4 SG1
5 USB5V3
6 D-OUTA3
7 D+OUTA3
8 SG1
Note:
The electric power consumption of the device connected with the
Type-A connector should be up to 0.1A or less. When the device that
exceeds this condition is connected, it would cause the failure of the
printer. The USB cable must be a shielded one.
B-4. Drawer Kick Connector
Pin No. Signal Name
1 DRSNS2
2 *DRD1
3 DRSNS1
4 +24V
5 *DRD2
6 SG
1 6
Connecting side
I/O direction
-- BUS-POWER5V
In/Out D-
In/Out D+
-- Grand
I/O direction
Out +5V for A1
In/Out D- for A2
In/Out
D+ for A3
-- Grand for A4
Out +5V for B1
In/Out D- for B2
In/Out D+ for B3
-- Grand for B4
I/O direction
Drawer sense signal 2
Drawer kick drive signal 1
Drawer sense signal 1
Drive power
Drawer kick drive signal 2
Drawer sense ground signal
49
Function
Function
Function
Input
Output
Input
Output
Output
Output