Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
C-2. HEX Dump
Turn off the printer power switch, put the paper in place, and turn on
the printer power switch while holding down the FEED switch on the
control panel. The printing described in Section 8.1 occurs. Press
the FEED switch for a short time. After "HEX dump" is printed as
shown below, press the FEED switch for about two seconds to start
the HEX dump mode.
In this mode, all the signals that are sent from the host computer to
the printer are printed in hexadecimal format. The printed data can
be used to confirm that the control codes that were sent from the
created program to the printer were correctly received.
To cancel this mode, turn the power switch off once.
HEX DUMP
↑
TEST PRINT
END
SET UP
HEX DUMP
TEST PRINT
Example of contents of HEX dump test printing
-HEX DUMP PRINTING-
000000 1B 40 1B 63 30 02 1B 6F. @. c0..o
Address Hexadecimal number ASCII
SELECTION ITEM
•
•
54
Werbung
Kapitel
Inhaltsverzeichnis
