Panasonic ES-RM3FX Betriebsanleitung Seite 15

To remove light dirt
3� Slide the cleaning shutter down
until it clicks into place�
4. Rinse the shaver head by
running water through the
water inlets located within the
cleaning shutter, as illustrated
in the image below�
Water
Water
inlet
5� After rinsing the shaver, turn it
off and shake it several times to
remove excess water�
6. Dry the shaver with a clean, dry
cloth, then slide the cleaning
shutter upward to close�
7. Store the shaver after drying it.
a Remove the outer foil section, thoroughly
dry the outer foil section, main body and
the socket.
• Leave them to dry in a shaded area,
out of direct sunlight.
b After the shaver has dried completely, install
the outer foil section onto the main body.
► Notes
• Be careful not to hit the shaver on the sink or any other objects while
draining the water. Failure to do so may cause malfunction.
Water
For heavy dirt
3� Run the shaver for 10 to 20
seconds, then turn it off�
4� Remove the outer foil
section and turn the shaver
on�
5� Clean the shaver and the
outer foil section with
running water�
6� After rinsing the shaver, turn
it off and shake it several
times to remove excess
water. Finish by drying the
shaver with a clean, dry
cloth�
15