Sony HVL-MT24AM Bedienungsanleitung Seite 25

7
When the macro flash controller is charged, press the
shutter button to take a photo.
The macro flash controller is charged when the flash-ready lamp on the
control panel of the macro flash controller and the indicator in the camera
viewfinder are both on.
When the correct exposure has been obtained for the photo just taken, the
flash-ready lamp on the control panel blinks.
 The photo will be under-exposed if taken before charging is complete.
 The use of a tripod or remote cord is recommended to reduce camera shake.
 A camera-to-subject distance of less than 0.5m, and a magnification ratio of
more than 0.15X (greater than 1:7), are recommended to get the best results
from the macro flash units.
 Always turn off the macro flash controller if the twin flash unit is not connected.
If the twin flash unit is not attached, but the controller is on, the camera flash
sync will be in effect and the resulting ambient exposures will be incorrect.
 The camera's AF illuminator is blocked by the adaptor ring or twin flash unit and
cannot be used for focusing.
Continued on the next page