Default Settings - Pce Instruments Pce-Ct 100 Bedienungsanleitung

13

Default settings

This section describes the device settings
- at initial start-up
- after total reset
- when batteries have been removed for a longer period of time
Device settings
Calibration
Single-value/block-value
statistics
Online statistics display
Autom. FN, Ferr, Non-
Ferr
Limit values
Continuous mode
Zero offset
File
Transfer contents
Backlight
Switch-off mode
Beeper
Unit of measurement
Welcome screen
Date + Time
Sprache
After a battery interruption lasting more than 20 seconds, the gauge will work as after a total reset.
In addition, the user is prompted to select the language and to set the date and time.
Condition after first
switch-on
Works calibration
Single-value statistics
Mean value and standard
deviation
Autom. FN (if available)
None
Off
Off
None
Statistics
Off
Automatic
On
µm
On
Must be set
Must be set
© PCE Instruments
57
Condition after total reset
Works calibration
Single-value statistics
Mean value and standard deviation
Autom. FN (if available)
None
Off
Off
None
Statistics
Off
Automatic
On
µm
On
Unchanged
Unchanged