HOMCOM 824-015V90 Bedienungsanleitung Seite 5

EN
OPERATION
The FAN may be operated by the manual controls located on the FAN(as shown in Figure
3) or by your remote control (shown in Figure2)
1. Place the FAN on a stable flat surface. Plug the cord set into a 220-240V~ electrical
outlet.
2. POWER
pressing the '
3. SPEED
( ), or high (
screen (shown in Figure 4).
4. MODE
NATURAL, and SLEEP mode(shown in Figure 4).
• NORMAL Mode
• NATURAL Mode
low speed(15s), it works as per this recycle.
• SLEEP Mode
speed at 30 mins, then transfer to middle speed at 30 mins and transfer to low speed
until fan stop working.
5. TIMER
operation from 1 hour to 10 hours(shown in Figure 4).
6. OSCILLATION
function.
: Turn the FAN on by pressing the '
' button again.
: You can adjust the fan speed to the desired level: low (
) by pressing '
: Pressing the '
: fan will start work at any speed you set up
:fan will start work at high speed(15s)middle speed(15s) and
: if you set the mode at high speed, fan will work at high
: The fan is equipped with a timer that allows you to set it's length of
: Pressing the '
( Figure 3)
'. The speed setting is displayed on the LED
' button will set the FAN into NORMAL,
' button will start and stop the oscillation
4
' button; Turn the FAN off by
), medium