Cleaning And Maintenance - Welltec Probot Rx3 Pro Bedienungsanleitung

Usage
Cleaning path
Place the device in the centre of the glass, as far away from the frame as possible and press the power
button briefly. When the robot detects the top edge, it will start cleaning horizontally from top to
bottom. When the cleaning is complete, the robot will return to the starting point.
Activate the X2 double cleaning mode for a more thorough cleaning. When activated, the robot will
first clean horizontally and when finished will start cleaning vertically.
Horizontal cleaning from top to bottom
Taking the device off the surface
When the device finished the cleaning or when cleaning has been stopped, hold the robot by its
1.
handle and long press the power button to turn it off and then take it off the surface.
If you want to take the device off the glass, but it is out of reach, use the manual control on the remote
2.
control or the WiFi app to bring it closer to you.
If you want to take the device off the glass, but it is out of reach and the manual control is not possible
3.
(e.g. in the event of misplacing or discharge of the remote control), hold the safety rope on the robot's
end and carefully pull the rope along the glass to the point where you can reach the robot.
www.Welltec.pro
X2 clean: First horizontal cleaning from
top to bottom and then vertical from
left to right.
42
Robot maintenance schedule
Element Cleaning frequency
Cleaning cloth After each use
Edge sensors Every two weeks
Tanks Once a month
Ultrasonic spray nozzles After each use
Air outlet Every two weeks
Air inlet Every two weeks
Track Every two weeks

Cleaning and maintenance

Proper care of your robot improves its durability and performance. Before cleaning the device,
disconnect it from the power supply.
Cleaning edge sensors
Clean them every two weeks or more
often with a clean, dry cloth.
www.Welltec.pro
Replacement Cleaning method
Every 3-6 months Rinse under water and dry.
- Wipe with a dry, soft cloth.
- Wipe with a dry, soft cloth.
In case of failure Wipe with a dry, soft cloth.
- Wipe with a dry, soft cloth.
- Wipe with a dry, soft cloth.
Clean in accordance with
-
the instructions.
Cleaning air inlet
Clean it every two weeks or more
often with a clean, dry cloth.
43