WELLTEC PROBOT RX3 Pro Bedienungsanleitung Seite 24

Cleaning and maintenance
Tracks cleaning
If the robot tracks are wet or covered with dust, they may lose their grip during cleaning and the robot
will be slipping and fail to move. In that case the tracks should be cleaned.
If the device is not plugged in, plug it in.
1.
Rotate the device so that the tracks are facing up. Long press the
2.
power button until tracks start to rotate.
The tracks will rotate for 2 minutes. Slightly press a soft cloth
3.
against the track centre and hold until the track completes at least
one complete turn. Hold the cloth firmly in hand so that it wouldn't
be pulled by the track inside the robot. If that happens, turn off the
device immediately by long pressing the power button and take the
cloth out of the device.
Repeat cleaning for the second track. After finishing the cleaning
4.
turn off the robot if it didn't turn off already.
Cloth cleaning
Frequent washing of the cloth significantly increases its efficiency
and life. It is recommended to wash the cloth by hand with a small
amount of detergent under running water. After washing, wring out
the cloth and dry it thoroughly before next use.
Tanks
Pour out the cleaning solution from the tanks. Rinse them with clean water and let them dry.
www.Welltec.pro 44
Ultrasonic nozzle replacement
Make sure that the device is turned off and unplugged.
Remove the screws on the both sides of the tank with a screwdriver.
1.
Take out the tank from the device carefully, as there is a nozzle power cable under the tank. Carefully
2.
unplug the nozzle power cable.
Take out the nozzle from the tank. Put the replacement nozzle into the tank. Ensure that the nozzle
3.
matches the tank perfectly.
Connect the nozzle power cable, put the tank back into the robot so that it fits perfectly into the slot,
4.
and then tighten the screws.
www.Welltec.pro 45