Cleaning Methods - Welltec Probot Rx3 Pro Bedienungsanleitung

Cleaning methods

Choose the right way
The method of cleaning windows or surfaces depends on how dirty they are.
Slightly dirty
Step 1:
Dirty
Use a clean dry cloth.
1.
Step 1:
Turn off the spray using the remote or app.
2.
Run automatic cleaning.
3.
Step 2:
Very dirty
Use a clean dry cloth.
1.
Step 1: Turn off the spray using the remote or app.
2.
Run automatic cleaning.
3.
Step 2:
After completing step 2, replace the cloth with a new dry and clean one.
8.
Step 3:
Run automatic cleaning.
9.
www.Welltec.pro
Use a clean dry cloth.
1.
Lightly soak the cloth with window cleaner using the spray
2.
bottle.
Turn on the spray using the remote or app.
3.
Run automatic or X2 double cleaning.
4.
After completing step 1, replace the cloth with a new and clean one.
4.
Lightly soak the cloth with window cleaner using the spray bottle.
5.
Turn on the spray using the remote or app.
6.
7. Run X2 Double Clean.
After completing step 1, replace the cloth with a new and clean one.
4.
5. Lightly soak the cloth with window cleaner using the spray bottle.
Turn on the spray using the remote or app
6.
Run X2 Double Clean.
7.
40
Usage
Moistening the cleaning cloth
Moisten the cleaning cloth using spraying bottle with glass cleaner before
starting the cleaning, but it shouldn't be too wet, as there may be stains due to
the cleaner excess flowing down the glass. If the cloth is very wet, the robot may
even slip and fall from the window. If it has been moistened too much, dry it until
it's just damp.
Dirty surface
If there is a sand or a lot of dust on cleaned surface, use robot with dry cleaning
cloth remove them from the surface first. Then replace used cloth with clean
cloth. This will protect the surface from scratching.
Alternatively, you can use a normal soft cloth to manually clean the surface of
sand and dust before starting the robot.
Very wet cleaning cloth
It is not recommended to use very wet cleaning cloth, as it may cause the device
to slip and fall off. If there's a need to use very wet cloth, be sure to follow the
steps below:
Soak the clean cloth with glass cleaner, squeeze out the cleaner excess, and
1.
dry it as much as possible.
Turn off the spraying function using the
2.
Start the cleaning. After starting, the robot will slide downwards or stand still,
3.
due to cleaner excess. Observe whether the device will begin to clean normally.
If not, absorb the cleaner from the cloth with tissues or paper towel until the
device's movement returns to normal.
www.Welltec.pro
button on the remote control.
41