Cleaning Methods - Welltec Probot Rx11 Pro Bedienungsanleitung

Cleaning methods

Choose the right way
The method of cleaning windows or surfaces depends on how dirty they are.
Slightly dirty
Step 1:
Dirty
Use clean, dry cloths.
1.
Step 1:
2. Turn off the spray using the remote or app.
3. Run automatic cleaning.
Step 2:
Very dirty
Use clean, dry cloths.
1.
Step 1:
Turn off the spray using the remote or app.
2.
3. Run automatic cleaning.
Step 2:
8. After completing step 2, replace the cloths with a new, dry and clean ones.
Step 3:
9. Run automatic cleaning.
www.Welltec.pro
1. Use clean, dry cloths.
2. Lightly soak the cloths with window cleaner using the spray
bottle.
Turn on the spray using the remote or app.
3.
Run automatic or X2 double cleaning.
4.
After completing step 1, replace the cloths with a new and clean ones.
4.
5. Lightly soak the cloth with window cleaner using the spray bottle.
6. Turn on the spray using the remote or app.
7. Run X2 double cleaning.
4. After completing step 1, replace the cloths with a new and clean ones.
5. Lightly soak the cloths with window cleaner using the spray bottle.
Turn on the spray using the remote or app
6.
Run X2 double cleaning.
7.
38
Usage
Moistening the cleaning cloths
Moisten the cleaning cloths using spraying bottle with glass cleaner before
starting the cleaning, but it shouldn't be too wet, as there may be stains due to
the cleaner excess flowing down the glass. If the cloths are very wet, the robot
may even slip and fall from the window. If they has been moistened too much,
dry them until they're just damp.
Dirty surface
If there is a sand or a lot of dust on cleaned surface, use robot with dry cleaning
cloths remove pollutants from the surface first. Then replace used cloths with a
clean ones. This will protect the surface from scratching.
Alternatively, you can use a ordinary soft cloth to manually clean the surface of
sand and dust before starting the robot.
Heavily soaked cleaning cloths
It is not recommended to use very wet cleaning cloths, as it may cause the device
to slip and fall off. If there's a need to use very wet cloths, be sure to follow the
steps below:
1. Soak the clean cloths with glass cleaner, squeeze out the cleaner excess, and
dry it as much as possible.
2. Turn off the spraying function using the
Start the cleaning. After starting, the robot will slide downwards or stand still,
3.
due to cleaner excess. Observe whether the device will begin to clean normally.
If not, absorb the cleaner from the cloth with tissues or paper towel until the
device's movement returns to normal.
www.Welltec.pro
button on the remote control.
39