Network Connection - Zehnder Comfoconnect Pro Schnellstartanleitung

Network connection

First setup: connecting ComfoConnect PRO to your network (wired or wireless).
Ethernet LAN wired connection
■
Just plug a RJ45 cable directly from your router (or switch) to the ComfoConnect PRO.
The "Internet" LED should become green if the ComfoConnect PRO gets connected to
internet or will stay red if your network is isolated. Once the ethernet cable is connected,
the gateway is ready to use.
Wi-Fi wireless connection
■
To initiate the setup of your new gateway, you will first need to connect your device (such
as a smartphone or a laptop) to the gateway's dedicated local access point. This initial
step is essential for configuring your gateway to join your home Wi-Fi network.
Follow the procedure below to connect and set up your gateway:
Laptop procedure
Locate the Network:
Scan for available Wi-Fi networks on your device.
■
You will identify the gateway's local access point named "ComfoConnectPro".
■
This unique network is specifically created for the initial configuration of your
■
gateway.
Connect to the Local Access Point:
Select "ComfoConnectPro" from the list of available networks.
■
When prompted for a password, enter the password located on the gateway's label.
■
Smartphone procedure
Scan the QR code located on the label under the device.
■
After scanning the QR code, the phone automatically connects to the gateway's
■
network without the need to enter any password.
Wi-Fi Configuration
■
To configure the gateway's Wi-Fi connection follow the procedure below:
Step Action
Open a browser and type the address http://comfoconnectpro.local
1
(or http://10.1.1.1 if the previous address is not working)
At the first configuration you will be asked to set a password. This is the
2
password to access the gateway's configuration panel.
3 Login using the password just set.
Select Network from the top menu, you will enter the network configuration
4 page.
Open WiFi section and DISABLE "Access Point" using the relative switch.
Once disabled "Access Point", you will have to choose the Wi-Fi network to
5
connect to. A pop-up window with the list of available networks will appear.
EN
5
Step Action
6 After selecting a network, enter the password to access it.
To confirm the configuration press then "Apply Configuration".
ComfoConnect PRO will restart and will connect to your network.
7 The "Internet" LED should become green if the ComfoConnect PRO gets
connected to internet or will stay red if your network is isolated.
Always comply with the safety regulations, warnings, comments and instructions
given in this document. Failure to comply with the safety regulations, instructions,
warnings and comments may lead to personal injury or damage to the device.
Maintenance - Service
The ComfoConnect PRO doesn't require any ordinary maintenance activity.
For general cleaning to remove dust from the ComfoConnect PRO use a dry duster.
Before every operation over the device please disconnect the electric power.
For other maintenance operations please refer to the Service manual.
Only Zehnder authorised personnel should open the unit.
Waste disposal
The parts of the packaging that can be recycled are:
plastic bag containing screws, plugs and clamp;
■
cardboard for the box.
■
Electrical equipment no longer in use must not be thrown away with
normal municipal waste. The substances and materials it contains must
be disposed of separately in an appropriate manner. At the end of life, the
device must be disposed correctly as it is a waste of electric and electronic
equipment (WEEE).
Contacts
For support please contact the local Zehnder Service Team.
6
EN