Zehnder ComfoConnect PRO Schnellstartanleitung Seite 4

Power supply
Rated voltage
EMI Requirements
Unpacking / Checking the delivery
Contact your supplier immediately in case of damage or incomplete delivery and
do not proceed with the installation.
Take the necessary precautions when unpacking the ComfoConnect PRO device.
■
Keep it upright when unpacking it.
■
The delivery should include:
The ComfoConnect PRO device;
■
Wall fastening kit (with screws);
■
1 ComfoNet data cable.
■
Check the identification plate to ensure that you have received the correct device
type.
Controls and LEDs description
On the front cover, five different LEDs indicating the actual working mode of the
device are visible. On the side cover of the device there are four buttons that have
different function.
LEDs/icons/buttons meaning are explained in the following table:
LEDs/Icons Meaning
ACTIVITY LED - Green
■
Slowly blinks to signal that the system is up and running.
POWER LED - Green
■
It is lit if the ComfoConnect PRO is powered.
EN
230VAC 50Hz (main power by AC/DC Converter) 12
VDC 2Amp by ZEHNDER auxiliary device.
Use only in combination with external AC/
DC adapter, certified according to IEC/EN
62368-1, providing 12 VDC output (ES1/
PS2 type), internally protected against both
output overload and short-circuit, with 2 A
max. available current.
To be compliant to Class "B" emission of EN
55032, when AD/DC adaptor is used, additional
Wurth ferrite mod 742 711 42 (or equivalent) and
must be inserted near to the VDC plug connector.
3
LEDs/Icons Meaning
ALARM LED - Red
■
Starts during the startup phase then turns off and blinks in case of errors.
ComfoNet LED - Green
■
Starts blinking during the access phase then stays lit if the communication is fine.
It blinks in case of communication errors.
INTERNET LED
■
It is green if the internet access is ok.
It is blue if Access Point (Direct-Access) is enabled.
It is purple if WPS is enabled.
It turns red if there is no internet access.
Buttons Function
AP (ACCESS POINT) BUTTON
■
By enabling Access Point mode, a new and temporary wireless network is created,
named "ComfoConnectPro". Connect to this network, enter the password located on
the gateway's label to configure the ComfoConnect PRO through a simple and easy web
interface. Open a browser and connect to the address http://comfoconnectpro.local
(or http://10.1.1.1. if the previous address doesn't work). If AP is enabled, the "Internet"
LED becomes Blue.
WPS BUTTON
■
You can easily add ComfoConnect PRO to the home Wi-Fi using the WPS button: by
pressing it once and enabling WPS functionality on the router, it should be enough
to automatically connect ComfoConnect PRO without having to enter any network
password. When WPS is enabled, Internet LED turns Purple.
RESET BUTTON
■
It is possible to reset ComfoConnect PRO by pressing and holding the reset button for
3 seconds (alarm LED will start blinking). Pressing and holding the reset button for 10
seconds will instead initiate a factory reset (all LED will turn off).
Installation procedure
For the installation procedures, scan the QR-Code on the Cover or refer to the Installer
Manual available at the following link:
https://www.product-registration.zehnder-systems.com/document/comfoconnectpro
In case of malfunctioning such as weird noise, bad smell, unplug the power supply
and call a Zehnder Authorised Representative.
Always comply with the safety regulations, warnings, comments and instructions
given in this document. Failure to comply with the safety regulations, instructions,
warnings and comments may lead to personal injury or damage to the device.
4
EN