Troubleshooting - Kärcher BRS 43/500 C Carpet Betriebsanleitung

Troubleshooting

Danger
Risk of injury!
Pull the plug from the mains before carrying
out any tasks on the appliance.
Caution
Risk of damage to the appliance on ac-
count of water leakage. Remove the deter-
gent tank before doing any work on the
appliance.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Fault
Appliance cannot be started
Too little or no detergent appli-
cation
Insufficient cleaning result
Appliance vibrates.
16
Faults
Remedy
Check if the mains plug is connected.
Reset the overload fuse by pressing it in.
Check the brushes for blockage due to foreign particles,
remove them if found.
Clean sieve.
Remove the nozzle, rinse under running water and rein-
sert it.
Replace the nozzle.
Check the correct positioning of the coupling in the deter-
gent hose.
Check the brushes for wear, replace if required.
Check the detergent dosing.
Check if brushes are fitted properly.
Transpose the brush rollers.
Submerge the brush rollers in hot water (approx. 80°C)
for about 15 minutes
– 6
EN