VEVOR RBSDGZD-005 Originalanleitung Seite 5

PART INCLUDED
IMPORTANT NOTE:The safeguards and Instructions appearing in this
page, are not meant to cover all possible conditions and situations that
may occur. It may be understood that common sense, caution, and care
are factors that cannot be built into any product. The person(s) installing,
operating is responsible for the work light, must execute these common
sense factors.
ASSEMBLY
①.Open the tripod and tighten the bolt
(A).
②.Fix the connecting rod (B) onto the
tripod using a knob and tighten it
completely.
③.Place the cross connection of the
I-frame on the concave part of the
connecting rod and tighten it with bolts.
④.Install the lamp head above the
installed I-frame (A1, A2, A3).
⑤.The height of (C) and (D) on the lamp
post can be adjusted by tightening them
on the left and loosening them on the
right.
- 4 -