Klarstein POWERGLIDE Bedienungsanleitung Seite 50

EN
50
Pan Dimension
The cooking zones are, up to a limit, automatically adapted to the diameter of the
pan. However the bottom of this pan must have a minimum of diameter according
to the corresponding cooking zone. To obtain the best efficiency of your hob,
please place the pan in the centre of the cooking zone.
Cooking zone
160 mm
180 mm
Note: The measurements givan above may vary according to the quality of the
pan used.
Start cooking
After turning on the appliance, the buzzer will beep once and all the indicators
will light up for one second, then turn off. This indicates that the appliance has
entered standby mode.
1. After the hob has been connected to the power supply and switched on, press
the ON/OFF control button. All indicators will show "--".
Note: If you don't choose a heat setting within 1 minute, the induction hob will
automatically switch off.
2. Place a suitable pan on the cooking zone you wish to use. Make sure the base
of the pan and the surface of the cooking zone are clean and dry.
Setting the heat level of the cooking zone
3. When you touch the heating zone selection control, an indicator light next to
the key will flash.
4. Select a heat setting by touching the slider control.
If you do not choose a setting within one minute, the induction hob will
automatically turn off. You will need to start over at step one.
You can change the heat setting at any time while cooking.
The base diameter of induction cookware
Minimum (mm)
120
140
Maximum (mm)
160
180