Interrupting Operation - Kärcher HD 6/15 CX Bedienungsanleitung

Opening/closing the trigger gun
 To open the trigger gun: Actuate the
safety lever and trigger.
 To close the hand spray gun: Release
the safety lever and trigger.
High pressure operation
Note:
The appliance is equipped with a pressure
switch. The motor starts up only when the
trigger gun is open.
 Roll off the high pressure hose totally
from the hose drum.
 Set the appliance switch to "I".
 Release the trigger gun. To do so, push
the safety catch towards the back.
 Open the hand spray gun.
 Set working pressure and flow rate
through turning (runless) at the pres-
sure- and amount regulation (B) (+/-).
Select spray type
 Close the hand spray gun.
 Turn the casing of the nozzle till the de-
sired symbol matches the marking.
High pressure circular spray
(0°) for specially stubborn dirt
Flat low pressure spray
(CHEM) for operating using de-
tergents or cleaning at low
pressure.
High pressure flat spray (25°)
for large dirt areas
Operation with detergent
WARNING
Unsuitable detergents can cause damage
to the appliance and to the object to be
cleaned. Use only those detergents that
have been approved by Kärcher. Observe
the dosage and other instructions provided
with these detergents. For considerate
treatment of the environment use detergent
economically.
Follow the safety instructions for using de-
tergents.
22
Kärcher detergents ensure smooth func-
tioning. Please consult us or ask for our cat-
alogue or our detergent information sheets.
 Take out detergent suck hose.
 Suspend end of suction hose in a con-
tainer filled with detergent.
 Set nozzle to "CHEM".
 Set dosing value for detergent to the
desired concentration.
Recommended cleaning method
 Spray the detergent sparingly on the
dry surface and allow it to react, but not
to dry.
 Spray off loosened dirt with the high-
pressure ray.
 After operations, dip the filter in clear
water. Turn the dosing valve to the
highest detergent concentration. Start
the appliance and rinse for one minute.

Interrupting operation

 Close the hand spray gun.
The appliance switches off.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
After the interruption:
 Release the trigger gun. To do so, push
the safety catch towards the back.
 Open the hand spray gun.
The appliance will switch on again.
Turn off the appliance
 Shut off water supply.
 Open the hand spray gun.
 Switch on the pump with the power
switch and allow to run for about 5-10
seconds.
 Close the hand spray gun.
 Set the appliance switch to "0/OFF".
 Pull main plug out of socket with dry
hands only.
 Remove water connection.
 Activate hand spray gun until device is
pressure less.
 Secure the trigger gun. To do so, push
the safety catch towards the front.
– 5
EN