English; Connecting To The Mains - Bosch GHP 5-14 Originalbetriebsanleitung

OBJ_BUCH-1762-002.book Page 11 Tuesday, November 22, 2016 10:02 AM

English

Safety Notes
Explanation of symbols
General hazard safety alert.
Never direct the water jet
at people, animals, the unit
or electric components.
Warning: High pressure jets can be dan-
gerous if subject to misuse.
According to the applicable
regulations, the appliance
must never be used on the
drinking water network without a
system separator. Use a separator as
per IEC 61770 Type BA.
Water flowing though a system sepa-
rator is considered not drinkable.
For self priming use special suction
kit 3 m long (F 016 800 335).
Safety Notes for pressure washer
Read all safety warnings and
all instructions. Failure to fol-
low the warnings and instruc-
tions may result in electric shock, fire
and/or serious injury.
The warning and information signs at-
tached to the unit provide important in-
formation for safe operation.
Apart from the information in the oper-
ating instructions comply with the gen-
eral safety regulations and regulations
for the prevention of accidents.

Connecting to the mains


The voltage indicated on the rating
plate must correspond to the voltage
of the power source.
Bosch Power Tools
 We recommend that this equipment
is only connected into a socket which
is protected by a circuit-breaker that
would be actuated by a 30 mA residu-
al current.
This is a class I unit and may only be

connected to properly earthed power
sources.

Remove the plug from socket when-
ever the machine is left unattended
for any period.

The electric supply installation
should comply with IEC 60364-1.

If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualified
persons in order to avoid a hazard.
 If the plug is damaged, pay attention
to the following:
 Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide ad-
equate protection against ingress of
water, etc. and cable entries require
effective sealing. Rubber shrouds
should be provided over cable glands.
Drip-proof (class IP X2 of BS 5490)
plugs and sockets to BS 4343 are
suitable for use indoors where the
plug is away from the water spray area
where the appliance is in use.
 Never touch the mains plug with wet
hands.
 Do not pull plug while operating the
device.
 Do not run over, crush or pull the
power supply cord or extension cord,
otherwise it may be damaged. Pro-
tect the cable from heat, oil and sharp
edges.
English | 11
1 609 92A 3ER | (22.11.16)