Specifications; Specific Safety Rules - Makita BSS610 Betriebsanleitung

ENGLISH
1. Red part
2. Button
3. Battery cartridge
4. Lever
5. Stopper
6. Base
7. Cutting line
8. Switch trigger
9. Lock-off lever
10. Shaft lock

SPECIFICATIONS

Blade diameter
Max. Cutting depth
No load speed (min
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
Intended use
The tool is intended for performing lengthways and
crossways straight cuts and mitre cuts with angles in
wood while in firm contact with the workpiece.
Explanation of general view
11. Hex wrench
12. Inner flange
13. Saw blade
14. Outer flange
15. Hex. bolt
16. Dust nozzle (accessory)
17. Screw
18. Hose
19. Vacuum cleaner
20. Rear handle
Model
at 90°
at 45°
at 50°
-1
)
Net weight
21. Front grip
22. Clamping screw
23. Rip fence (Guide rule)
24. Adjusting screw for 45°
25. Adjusting screw for 90°
26. Triangular rule
27. Limit mark
28. Brush holder cap
29. Screwdriver
BSS610
165 mm
347 mm
D.C. 18V

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to
Circular Saw safety rules. If you use this tool unsafely
or incorrectly, you can suffer serious personal injury.
DANGER:
1. Keep hands away from cutting area and the blade.
Keep your second hand on auxiliary handle, or
motor housing. If both hands are holding the saw,
they cannot be cut by the blade.
2. Do not reach underneath the workpiece. The guard
cannot protect you from the blade below the
workpiece. Do not attempt to remove cut material
when blade is moving.
CAUTION: Blades coast after turn off. Wait until blade
stops before grasping cut material.
3. Adjust the cutting depth to the thickness of the
workpiece. Less than a full tooth of the blade teeth
should be visible below the workpiece.
4. Never hold piece being cut in your hands or
across your leg. Secure the workpiece to stable
platform. It is important to support the work properly
to minimize body exposure, blade binding, or loss of
control.
A typical illustration of proper hand support and
workpiece support. (Fig. 1)
5. Hold power tool by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
57 mm
40 mm
36 mm
3,700
3.2 kg
5