Klarstein 10031433 Bedienungsanleitung Seite 81

2. Fix the power connection wire and signal control wire with wire clip (only for cooling and heating unit).
Note:
• After tightening the screw, pull the power cord slightly to check if it is firm.
• Never cut the power connection wire to prolong or shorten the distance.
Step 6: neaten the pipes
1. The pipes should be placed along the wall,
bent reasonably and hidden possibly. Min.
semidiameter of bending the pipe is 10cm.
2. If the outdoor unit is higher than the wall hole,
you must set a U-shaped curve in the pipe
before pipe goes into the room, in order to
prevent rain from getting into the room.
Outdoor Condensate Drainage
During heating operation, the condensate and
defrosting water should be drained out reliably
through the drain hose. Install the outdoor drain
connector in a 25 hole on the base plate and attach
the drain hose to the connector so that the waste
water formed in the outdoor unit can be drained
out. The hole diameter 25 must be plugged.
Whether to plug other holes will be determined by
the dealers to actual conditions.
The 18K MC ,24K MD UNIT drainage hole consists
of two 25 and two kidney holes (see the fig.1). The
drain plug consists of one 25 and two kidney plugs.
(The figures in this manual may be different with the
material objects, please refer to the material objects
for reference.)
81
U-shaped curve
drain hose
18K MC UNIT:
Didney holes Drain - water hole
Bottom frame
24K MD UNIT:
Didney holes Drain - water hole
Bottom frame
wall