Troubleshooting - Gastros InductWarm 130+ Betriebs- Und Montageanleitung

Voltage range
Maximum input power
Electrical fuse protection
Frequency
Dimensions
Connection

Troubleshooting

Fault
LED is not flashing
LED flashing
Infra red remote control is not
working
Dish is not warm enough
20
Technical Information of the InductWarm
Cause
No power supply
Power line fuse tripped
Appliance not switched on
Appliance defect
Pan is not detected
Battery is empty
Sender or receiver are solid
No elecrticity between battery and
remote control
Incorrect placement of dish
Too little energy input
Dish is not induction compatible
® 130+ Built-in Element
220 – 240 V AC
750 W
10 A
50 Hz
350 x 350 x 110 mm
C13
Remedy
Plug the appliance in,
check the plug connection
Check and reset the fuse
Check the plug connection, turn on
the power switch on the bottom of
the device
Contact customer service
Pan too small or not
induction compatible
Replace the battery
Clean sender or receiver
Ensure contact between battery and
remote control
Ensure right position above the
induction coil
Increase power level
Check induction compatibility of
dish