Phottix Mitros TTL Flash Benutzerhandbuch Seite 8

To use:
1. Press the button until M is displayed on the flash LCD.
2. Press the button to enter the power adjustment screen. The power
level will flash and be highlighted.
3. Press the or
4. Press the button to exit the power adjustment screen.
5. When the flash ready light is illuminated red the flash is fully charged and
ready to fire.
6. Pressing the button will fire the flash at the manual power level you
set. This is useful when taking meter readings.
Please note:
- Half pressing the shutter button will display the effective manual flash pow-
er range on the Flash LCD.
- When HSS is enabled, the manual power level can be set to a minimum of
1/128, not 1/256.
Multi: Stroboscopic Mode
With Multi Stroboscopic mode a series of rapid flashes will be fired. The flash
count, frequency and power of these flashes can be programmed on the Phottix
Mitros. Multi mode is useful for capturing multiple images of a moving subject
in the same photo and other special effects.
The frequency of the effect (in Hz. - number of flashes per second), the total
number of flashes and output levels can be set.
To use:
1. Press the button until Multi is displayed on the flash LCD.
2. Press the button to adjust Multi settings. Displayed (from left to right
on the LCD) Power, Frequency (HZ) and Flash Count. Power is highlighted and
flashing upon entering the adjustment screen.
3. Press the and
(HZ) and Flash count.
4. Press the and
adjust Power, Frequency (HZ) and Flash count to the desired levels.
5. Press the button to exit the adjustment screen.
Please note:
1. Overheating and damage can result from excessive use of the Multi Strobo-
scopic Mode. Do not use more than 20 times in succession.
2. When overheated the flash will automatically increase charging time until
the flash temperature has decreased.
3. Power level can only be set to a maximum of 1/8 in Multi mode.
Stroboscopic Mode and Shutter Speeds
To determine the proper camera shutter speed to be used with various Strobo-
scopic Mode variables, use the following formula:
Number of flashes / Frequency = Shutter Speed
8
buttons to adjust the flash power.
buttons to change between Power, Frequency
buttons while the setting is highlighted to
INSTRUCTION MANUAL
En
Example: 5x (number of flashes) / 10 Hz (Frequency) = .5 second shutter speed.
This is a rough guideline: You may need to increase or decrease the shutter
speed to get the desired result.
Multi Stroboscopic Mode Output Chart
Multi Stroboscopic mode output is affected by the battery level. Please refer to
the following test result.
Use NI-MH batteries
"100+" means more than 100 times.