Disposal - VOLTCRAFT MSW 700-12-G Bedienungsanleitung

The connected consumers are not working and the "fault" LED is lit
• The consumers' power consumption is too high for the inverter; overload protection has
been activated.
• The consumers' power consumption is too high when starting up; overload protection has
been activated.
an alarm sounds
• Undervoltage recognition has been activated. The rechargeable battery that is used for
voltage/current supply of the inverter is flat. Connect the inverter to another, fully charged
rechargeable battery.
• The overtemperature protection has been activated. Switch the inverter off and let it cool off
sufficiently.
Check if the inverter is sufficiently ventilated.
Operate the inverter in a cooler environment.
Connect a consumer with lower power consumption. With one consumer each connected to
the two outputs of the inverter, try disconnecting one of them from the inverter.
The operating time is too short
• Use a rechargeable battery with higher capacity.
• The rechargeable battery is not fully charged. Disconnect the rechargeable battery from the
inverter and charge it entirely.
• The rechargeable battery is old/flat; replace it by a new one.

11. DISPOSaL

The product does not belong in the household waste.
Dispose of the product according to the applicable statutory provisions at the end of
its service life once it has become useless.
38