AEG RV 3.5 Bedienungsanleitung Seite 22

22
Step 7: Connecting the transmitter supply
cable
Remove the cover of the reversing light. Remove
the bulb holder from the reversing light housing.
Find the vehicle supply cables to the reversing
light. Please refer to the automaker's manual.
Caution! Disconnect the negative cable from the
vehicle's battery before working on the vehicle's
electric circuit! Stored information, codes and pro-
gramming may be lost!
Now connect the vehicle's 12 V + (positive)
power supply to the reversing light to the red
transmitter cable. Then connect the vehicle's
12 V - (negative) earth cable for the reversing
light with the black transmitter cable (see
image 7).
Transmitter
12 V supply cable
Camera cable
Image 7
Using the two cable clamps
to the reversing light and follow the following
steps for connecting the respective cables.
+ 12 V DC reversing light
Red
Cable
clamp
Black
Reversing
Earth
light
Camera
connect the cables
7
Place the 12 V +
(positive) reversing light
cable sideways into the
clamp connector (see
7
image 8).
Place the red transmitter
cable sideways into the
clamp connector (see
7
image 9).
Using a pair of pliers
(not included) push the
protruding metal contact
into the cable clamp
7
This will connect the two
cables.
Close the cable clamp
fuse cover.
7
Using the second cable clamp
vehicle's 12 V - (negative) reversing light cable
with the black transmitter cable as shown in
images 8 - 11. Then reconnect the negative cable
to the vehicle's battery.
Caution! If you are unfamiliar with the
I installation and the connections or are
unsure with one of these steps, please
consult a specialist regarding the installation!
There is a risk of property damage or personal
injuries!
Image 8
Image 9
.
Image 10
Image 11
connect the
7