AEG RV 3.5 Bedienungsanleitung Seite 21

Then clip the plastic ring
from the outside of the vehicle.
Step 3: Mounting the camera brackets
Mount the two camera brackets
cable, also the number plate frame. Be sure the
distance between the two brackets
than 4 cm (see image 3). The camera may be
mounted above or below the license number.
Image 3 shows installation above the license
number.
Caution! The location of the camera brackets
may not impair the functionality of the license
number light! If it impairs the license number
light mount the camera on the opposite side.
Minimum distance 4 cm
Image 3
Step 4: Mounting the camera
Guide the plug for the camera cable
the plastic ring and into the interior of the
8
vehicle or the trunk lid. Mount the camera
the camera brackets 9
sides (see image 4). Mount using the two screws
and the two clamping nuts
5
Stop turning the clamping nuts when you feel
resistance and the camera is securely connected
to the bracket. Be sure the cable outlet at the back
of the camera always points upward to maintain
the maximum swivel range.
into the borehole
8
and, if appli-
9
is no less
9
Example: top
mounted camera
through
1
to
1
evenly spaced from the
(see image 5).
6
The plastic ring may optionally be sealed with
8
conventional sealing compound on both sides to
prevent water from entering.
Image 4
5
Image 5
Step 5: Mounting the license number
Now mount the plate (see image 6).
Image 6
Step 6: Running the camera cable
Now run the camera cable
nection with the cable of the radio transmitter
in the vehicle's interior / cavity. Be sure the cables
aren't pinched or knotted. Now connect the plug
from the camera cable
radio transmitter .
11
GB 21
1 9 6
to establish a con-
1
11
to the socket of the
1