Care And Maintenance - Hilti UW 10 Bedienungsanleitung

9. Care and maintenance

9.1 Operations after fastening
Withdraw the axle (7) again while releasing the detent
(40). Remove the revolving magazine (1).
en
Holding the drum assy (2) over a soft surface e.g. a cloth,
and working from the sealing cap end, push out the bar-
rels (13) firmly using the grip end of the extractor. Push
out two barrels (13) on each side of the screw and then
rotate the drum assy (2) through 180° before pushing
out the remaining two barrels. In doing so, the used seal-
ing caps are also removed.
Eject spent cartridge cases using the ejector.
After reinserting the barrels (13) in the revolving maga-
zine, the next loading operation can be begin immedi-
ately.
22
Printed: 08.07.2013 | Doc-Nr: PUB / 5071291 / 000 / 01