17.5. Faktory reset
Select this entry and confirm the subsequent prompt with yes to reset the device to
the factory settings.
All existing network information will be deleted and will have to be re-entered to
establish a network connection.
17.6. Software Update
You can search for and, if need be, install software updates using this function.
Auto-Update
Select the entry yes to enable regular automatic searches for software updates.
Check now
Starts the search for software updates immediately.
17.7. Start wizard
Starts the setup wizard as described in the section 'Using the device for the first
time' .
17.8. Info
This section displays the software version and the device's radio ID.
17.9. Display illumination
You can adjust the display lighting with this function:
− Dim the display in standby mode or operating mode after a specified time
− Display brightness
Setting the dimming time in operation
Select the entry Timeout: and then turn the OK rotary dial to select on, 10,
20,30, 45,60, 90, 120 or 180 seconds.
Display brightness in standby
Select the entry Power-on Level by turning and then pressing the OK rotary
dial and then set the desired brightness level to Medium or Low.
Setting the dimming time in standby
Select the entry Standby Timeout: and then turn the OK rotary dial to select
on, 10, 20,30, 45,60, 90, 120 or 180 seconds.
Display brightness in operation
Select the entry Standby Level by turning and then pressing the OK rotary dial
and then set the desired brightness level to Bright, Medium, low.
86