VEVOR RC-1803I Originalanleitung Seite 11

3
Take parts Ex2, Fx2, Nx4, Px4, Rx4, ADx4, and ACx8 for
assembly as shown in the figure. Pay attention to the
direction of the E/F components during assembly, and do
not tighten the knob AD after assembly to ensure that the
E/F components can move and adjust the position on the horizontal pipe.
4
Take parts B, O, ABx2, S, K and assemble them on the assembly in step 3, as
shown in the figure. After tightening the nut O, loosen it by half a turn and fix it
with a K pin.
- 10 -