After Each Use - Rowenta X-Clean 2 Gebrauchsanweisung

AFTER EACH USE

1 - EMPTY THE DIRTY WATER TANK
1
Remove the dirty
water tank.
3
Flush the waste
down the toilet.
4
Place the dirty water
tank cover back
2 - FILL THE CLEAN WATER TANK
WITH WATER
1 Remove the
clean water tank.
4
Place the clean
water tank back.
3 - LAUNCH THE SELF CLEANING
PROGRAM
Device must be on the charging base. The charging
base must be connected to a power source.
1 MIN 30
90 SECONDS
Self-cleaning will not start if battery level is below 20%*.
*If your battery level logo blinks, please put the device on the charging base and wait before
launching self-cleaning.
If the dirty water tank is full, the self-cleaning program stops.
To resume, empty the dirty water tank and restart the self-cleaning program.
START SELF-CLEANING
STOP SELF-CLEANING
Press the ON/OFF button or press Self-cleaning button.
2
Open the clean
water tank.
The self-cleaning program cleans the roller.
Self-cleaning
button is located
at the top of the
handle.
PRESS
2
Remove the dirty water
tank by pulling.
OR
3
To separate liquid and solid
waste, use the waste separator
on the cleaning brush. Flush the
liquid waste down the toilet and
throw away the solid waste.
5
Place the dirty
water tank back.
PRESS
Press the Self-
cleaning button
once.
PRESS
OR
WATCH THE
VIDEO HERE
WATCH THE
VIDEO HERE
3 Fill the clean
water tank*.
* Use water between
10 °C and 50 °C.