Troubleshooting And Solutions; Specifications - Rowenta X-Clean 2 Gebrauchsanweisung

6 / TROUBLESHOOTING AND SOLUTIONS

Issue
The appliance has less
suction, makes noise
or a whistling sound,
or drops debris on the
ground.
The floor is too wet.
The floor is not wet
enough.
The appliance does
not clean the floor
properly.
The appliance
damages the floor.
The appliance shuts
down on its own.
The roller is stuck.
The appliance
splashes water
everywhere.
The roller is very dirty.
I want to remove
the handle of my
appliance in order to
store it

7 / SPECIFICATIONS

WATER TANKS CAPACITIES
Description
Clean Water Tank
Dirty water tank
Possible Causes
The appliance's air channel
is blocked.
Failure of the vacuum
cleaner.
The water flow is too high
or the roller is soaked.
Water leakage.
The clean water tank is
empty.
The water flow is too low.
The roller is dirty.
The appliance has not been
set to the correct mode for
cleaning.
The appliance has been
used without the roller.
A foreign object is stuck in
the cleaning head.
The dirty water tank is full.
The battery level is too low.
An object or fibers are
blocking the roller.
The protective cover is not
mounted properly.
The roller is mounted
incorrectly.
The appliance was used to
clean a very dirty area or
the roller was not cleaned
properly during the last
cleaning session.
Capacity (ml)
730 ml
440 ml
Solutions
Clean the suction head, clean the air
channel, clean the filter and foam (see
user manual).
Please contact our after-sales service.
Make sure you are using ECO mode.
Please contact our after-sales service.
Fill the clean water tank with water.
Make sure you are using Max mode.
Launch Self-cleaning cycle, then clean
the roller by hand.
Use MAX mode to optimize cleaning.
Always use the appliance with well fixed
roller and a full clean water tank.
Clean the cleaning head.
Empty the dirty water tank.
Charge the appliance on its base.
Disassemble the roller and remove any
items that are blocking the rotation.
Detach the roller and replace it
correctly.
Launch a self-cleaning cycle.
Hand-clean the roller afterwards if
necessary.
Change the roller if previous steps are
not sufficient.
Use a flat tool. Insert the tool into the
hole in the side of the handle and pull
the handle out of the product.