Conrad 12 05 99 Bedienungsanleitung Seite 16

- Carefully bend back the wire in its original position.
- Put the screw back into the device. Carefully tighten the screw.
Closing = turn right (clockwise).
Do not let batteries lie around openly. There is the risk of
batteries being swallowed by children. In such case,
seek instant medical care.
Do not let batteries lie around openly. There is the risk
of batteries being swallowed by children. In such case,
seek instant medical care. Leaking or damaged batter-
ies might cause acid burns when getting into contact
with skin, therefore use suitable protective gloves. Nev-
er try to recharge batteries. Do not throw batteries into
fire.
Environmental note!
The end user is under legal obligation to take back all
used batteries and rechargeable batteries (from round
cell batteries to lead rechargeable batteries), to dis-
pose of them via domestic waste is not permitted.
You can return used batteries and rechargeable batter-
ies free of charge, to supermarkets, dealer's shops or
local collection centres where special collection boxes
are set up for this purpose.
You should also contribute to environmental pro-
tection.
16
Self-Test
To avoid wrong readings, the operability of the multitester needs to
be checked by a self-test before each use and after each change of
batteries. Please check the device for damage(s) such as e.g.,
breaks on the housing etc.
Touch the tip (1) of the tester with one hand
and at the same time touch the battery com-
partment lid (3) with the other hand.
When the red LED (2) starts blinking, the multi-
tester is in working order and can be used.
In case the red LED does not blink, the
device must not be used. If necessary
change the batteries.
Alternating Voltage Detection
a. Direct contact (70 to 250V alternating voltage)
Touch the electric conductor (phase) with the measuring tip (1). If
the LED (2) lights up, there is voltage.
Note: during this test the battery compartment lid must not be
touched with the finger.
b. Indirect contact (70 to 500V alternating voltage)
During this test the tip of the tester must not touch the
tested line (device) directly.
Please note that the LED (2) only goes out after approx.
0.5 to 2 seconds after removing the device from the
voltage because of the temporary memory function.
17