VEVOR PAC11 Benutzerhandbuch Seite 16

8.Problem: Cleaner leaves patches.
Solution:
● Ensure the wheel on top of the Cleaner body is rotating freely and is screwed on securely.
● Adjust return jets downwards.
● Verify proper hose length.
● Ensure the cleaner sits flush with the pool floor. Adjust the position of the hose weight if necessary. This
should be done at the deepest part of the pool.
● Check that the hose sections are straight; if not, lay the hose in a straight line in the sun to relax the memory.
9.Problem: Cleaner sticks on walls and floors.
Solution:
● Ensure there is a valve installed in the skimmer/weir.
● Inspect the Regulator Valve and flush away any debris build-up.
● Check the Mat for wear. Please note that if the mat is torn in these positions, operating is okay. (See Figure 9)
● Try increasing or decreasing the flow to your cleaner via the regulator.
10.Problem: Cleaner is not sitting flat on the bottom.
Solution:
● Ensure there is a valve installed in the skimmer/weir.
● Inspect the Regulator Valve and flush away any debris build-up.
● Ensure the wheel on top of the Cleaner body is rotating freely and is screwed on securely.
● Adjust return jets downwards.
● Verify proper hose length.
- 15 -