VEVOR PAC11 Benutzerhandbuch Seite 14

3.Problem: Cleaner gets stuck on steps.
Solution:
● Adjust the return jets toward the problem area to guide the cleaner away from the steps.
● Verify proper hose length.
● Ensure the cleaner sits flush with the pool floor. Adjust the position of the hose weight if necessary. This
should be done at the deepest part of the pool.
● Increase or decrease the flow to your cleaner via the regulator.
● Check the mat for wear. Please note that if the mat is torn in these positions, operating is okay. (See Figure 9)
4.Problem: Cleaner travels in a repetitive pattern.
Solution:
● Adjust return jets downwards.
● Verify proper hose length.
● Ensure cleaner sits flush with the pool floor. Adjust the position of hose weight if necessary.
● This should be done at the deepest part of the pool.
● Remove or add one hose section.
● Inspect the Regulator Valve and flush away any debris build-up.
● Check that the hose sections are straight; if not, lay the hose in a straight line in the sun to relax the memory.
● Twist each hose section a half-turn at each connection point.
● Ensure the wheel at the top of the Cleaner head is rotating freely.
- 13 -