VEVOR PAC11 Benutzerhandbuch Seite 12

1.Problem: Cleaner don't move at very beginning but the hoses are trembling.
Solution:
● Clean and empty the pump basket and the empty skimmer/weir basket.
● Ensure the filtration system is thoroughly cleaned. Clean sand/cartridge filters on your pool pump as per
manufacturer specifications.
● Check the Cleaner head for blockages.(See Figure 1)
● Check the outlet holes on foot pad for blockages.(See Figure 2)
● Inspect the regulator valve and flush away any debris build-up. (See Figure 3)
● Check if the pump power is too big; try decreasing the flow to your cleaner via the regulator, and adjust the
regulator by turning the knob to the "-" direction slowly until the cleaner runs well. (See Figure 4a)
● Check the cleaner diaphragm is not blocked or damaged, or loosened from the inner pole, or the inner pole is
damaged. (See Figure 5 and Figure 6) Please note that the snap ring should be fixed on the diaphragm. If you
need to check the diaphragm and inner pole status, please check the DIAPHRAGM ASSEMBLY process in the
instruction to disassemble this part from the body.
● Make sure the curved tips of the Mat are facing upwards. You will find "TOP" on the top side. (See Figure 7)
● Make sure the mat is assembled in right place on foot pad as picture show and can move freely around the
foot pad. (See Figure 8)
● Check if the hoses are blockage or leaking. For leaking you could check with your hand on the surface of the
hoses in the water while the pump is running; you will feel suction when your hand is on the leaking surface.
● Check if the pump has air inside and causes less suction power.
● Consult a pool shop in your area.
TROUBLE SHOOTING
- 11 -