Fitting; Sart-Up; Reset - Siemens 5TC1 Serie Montageanleitung

GB

3. Fitting

The shutter control timer 'Komfort' is installed together with the shutter control insert
without extension in a mounting box as per DIN 49073.
The connecting terminals of the insert must be at the bottom.
Description, fitting and connection of the insert see separate instructions.
Recommendation: Fitting of the motor control insert is much easier if a deep mounting
box is used.
4. Start-up
Info: Due to statical charges occurring during packing, storage and transport, the pro-
gram memory may contain random data.
To set the device back to the factory settings, a reset after the first installation is therefore
required.

4.1 Reset

38
Place the attachment ‚ together with frame ƒonto
the insert .
The electrical connection is established by contacts
„ and …
Depress the keys
seconds until all figures and symbols appear on the
display.
Thereafter, 12:00 starts flashing to indicate that the device
has been reset to the basic values.
and at the same for about 7
Set Mode
Fitting