Grundig RR 950 Bedienungsanleitung Seite 15

Fast Winding Of Tape
To listen to your recording the tape must first be
rewound to its beginning. To do this depress the
rewind button @ If however, you wish to
pick out a particular recording from a full tape or
if you wish to by-pass part of a recording, then
you must wind the tape forward. For this, press
the forward wind button
When the required tape position has been reached
depress the start button @. The pause button @
wili not lock during tast wind operation.
Counter (Tape Position Indicator)
The counter @ is set to 000 by pressing the reset
button. When starting to record always write down
the counter reading together with the title
also at the end of the recording when there
still tape left for further recordings). For playing
back also set the counter @ to 000 after fitting
the cassette. Then, by winding the tape forward
you can select any title by referring to the count-
er. This of Coutse is only valid if the cassette
has been fully wound or rewound before it is in-
serted
Automatic End of Tape Stop
The tape run is automatically stopped at tape
end on all tape run functions and the outtons
On record the record button@ is also released.
For cassette playback the set must be switched
on with switch@ and the start button @ pressed.
The volume and sound image can be adjusted
with controls O to @. When connecting external
loudspeakers the built-in loudspeakers
switched off.
For reproduction via headphone using socket O,
the built-in loudspeakers are also switched off. If
the headphone is turned by 1800 and plugged in,
the reproduction will occur via headphone
loudspeakers simultaneously.
Recording with the Built-in Microphones
Switch the set on With switch O. No other ac-
cessory must be connected to universal socket O.
Depress pause button Depress record
@ with VAT button @ and start button @. Make
a short speech test to adjust the automatic
control. Release the pause button and
cording. Volume control @ must be set to mini-
mum.
(and
A few test recordings will show the most favourable
is
method of recording taking into consideration
distanr•e from the microphone @
Connection of Accessories to Universal
Input/Output Socket
(See fig. on page 5).
To this socket you can connect:
The GRUNDIG microphone GCM 309 Report.
With remote control (motor start/stop)
The GRUNDIG stereo condenser
wilt
GCMS 333 or two condenser microphones
GCCM 920 with the adapter cable 278 a.
will be
When recording through external
and
test recordjngs should always be made first.
When speaking close into
use of wind shields 404 is recommended.
A record player with a crystal
pick-up system, if it is uséd for rerecording of
button
records. For built-in record
cabinets or phono combinations)
level
rate output sockets for tape and phono, con-
begin re-
nection can be made using
necessary to disconnect the cable when play-
ing records or making recordings.
the A second cassette/tape recorder
using cable 242. For some units the adaptor
293 or 296 may be necessary.
A tuner amplifier for playback
cordings or to record using
A TV receiver using adaptor
or HiFi/TB adaptor 481
When recording from records or tapes try to find
out the loudest passage to adjust
correct recording level. Before starting
microphone
return the pick-up arm to the beginning
ord or rewind the tape you want to copy.
microphones
microphones, the
or ceramic
players (music
with sepa-
cable 242. It is not
to copy tapes
of cassette re-
cable 242.
cable type 484
the unit to the
the recording
of the rec-
15